I’m almost ready to start putting the panel back together. I’ve floxed bars into the sides of the fuselage to tie into the bar on the bottom of the panel. Hopefully this will stiffen it enough to allow it to be used to rack your seat fore and aft. I’ve also covered the panel in […]
Read More
I decided that one of my covers wasn’t quite good enough of fit for upholstery, so I added a little material all of the way around it, and then sanded it back until it fit very nicely. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et […]
Read More
UPDATE: Here is a link to these installed in the interior section. I’d previously bought green “Street GLow” LED light strips for my fuel gauge lighting, hooked to a Superior Panel dimmer, but now all of the rest of the interior lighting is in either blue or aviation white/blue so I’m changing these out as well. I’ve […]
Read More
Updating the panel is turning into a bit of a drawn out affair. However, I am making progress. Here you can see where I’ve extended the edges of the panel so they fit very nicely to the sides of the fuselage. I may have even made these too tight for the interior, time will tell. […]
Read More
As I mentioned in the blog, I’ve decided to move my brake line exit from by the pilot seat to forward of the canard bulkhead. This will allow a much cleaner interior installation, and the brake lines will come through the same bulkhead opening as the wiring, which I’ve added some windlace (from the doors) […]
Read More
I noticed one day that Mark had posted a fix for a problem he was having with his doors. It seemed surprisingly like one were were having, namely that the outside door handle was rubbing and leaving marks on the outside skin paint. When he pulled his doors, he found that the foam was crushed […]
Read More