After a lot talk on the reflector, and a bit of a spongy feel to our Matcos (and a desire to have the toe brake option to keep us from having to worry about landing with a brake locked), we decided to “upgrade” to the Cleveland brakes with the toe brake option. Cleveland Wheel and […]
Read More
We’ve purchased the dual axis digital autopilot from Blue Mountain. This is a really cool system, in that it can not only hold a course and altitude, it can climb to an altitude, or at a prescribed rate, or follow a flight plan that you enter into the EFIS. This is a very interesting system, in […]
Read More
The glare shield will also house a defogger for the pilot side of the windscreen that the bilge blower will power. There will be a separate diverter valve that allows the warm air to be diverted from the floor heat vents to the defogger. Defogger plenum and Deflector Defogger Plenum Mounted Final Panel and Glareshield
Read More
Here is another situation where we’ve decided to stray from the manual. The factory system is a candy-cane shaped fiberglass spring system, with a linear actuator pushing against it to provide pressure relieve to control stick’s pitch inputs. This spring is reported to be of mixed effectiveness, and of sketchy reliability, so we’ve elected to […]
Read More
We have to make a mating flange for the fuel servo, where the fuel is mixed with induction air. Here I’ve taken a piece of scrap aluminum with a paint cap glue to it, and then waxed and covered with a mess of BID. Once cured, just pop it all apart and trim. Fuel Servo […]
Read More
The engine plenum that we showed you above was a little too big, it was for the 300HP IO-540-K “angle-valve” motor. We have the IO-540-D, which is normally a 260HP motor, although ours is pumped up with high compression pistons and electronic ignition to above 300HP. Here are pictures of us glassing the fore and […]
Read More