These are now pre-molded at the factory. We’ve cut the 5/8″ lip for the flange onto the fuselage, and sanded the door to fit. We have done some finishing work with Cabosil, filling the void between the hatch and the flange. This is accomplished by duct taping the cover and the pressing it down into […]
Read More
OBSOLETE. These pedals were replaced when we upgraded to the Cleveland brakes with the toe-brake option. Assembling the rudder pedals is a pretty straightforward exercise in connect-the-dots. Of note is the fact that the back of the pedal has an arm that actuates the brake on one side of the plane for steering on the ground (the nose wheel […]
Read More
The panel attachment brackets were laid up as part of the fast build fuselage. The screw and nut plate were not installed, but we will hold onto this to see if we use the factory panel or not (we’re considering a carbon fiber panel). We have installed the factory panel in the expectation that we […]
Read MoreDuring Head Start week we fitted the canard. First we leveled the plane, and then progressively sanded underneath the canard until it just rested on the canard bulkhead, the we checked it’s incidence. Once the incidence was right we pilot drilled for the lift tab bolts. This section recommends trimming the elevators to fit the […]
Read More
The seat hard-points were installed using the factory placement guidelines as a starting point, however our seats have a large amount of side-bolstering, so we mounted them slightly off-center, but the specified 35″ from the canard bulkhead. The rear seats were trial fitted in different locations, to allow for different operational characteristics. We tried allowing […]
Read More
Fuel venting is through a common vent system in the Velocity. The two main tanks and sump all come to a common point, run to the top of the firewall to avoid any fuel spillage, and then exit through the bottom of the plane. I’ve installed an option check valve to allow cabin air to […]
Read More