Today Dave installed the strake pocket upholstery. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex ea commodi consequatur. Quis aute iure reprehenderit in voluptate velit […]
Read More
Dave arrived yesterday and got to installing our interior, and has enough done that I wanted to share some pictures with folks. Overhead duct and NACAs covered Overhead duct covered Overhead duct covered NACAs covered Door roll beams covered Door roll beams covered Painting micro around window to match trim Starting to cover the door […]
Read More
UPDATED: new pictures The third panel is progressing nicely. In the last update I’d just covered the panel in carbon. Since then I’ve pulled the harness into the copilot side conduit and started terminating the wires. I took this week off as my ‘spring break’ and spent all of it connecting wires. I’ve got the […]
Read More
I decided to build upholstery covers for my fuel gauges to hide the LED lighting units. To do this I bought an extra bubble from Vance Atkinson and covered it in duct tape, then laid 2 BID over top. Once that cured I cut the bubble area out with a Dremel and put the light […]
Read More
I’m almost ready to start putting the panel back together. I’ve floxed bars into the sides of the fuselage to tie into the bar on the bottom of the panel. Hopefully this will stiffen it enough to allow it to be used to rack your seat fore and aft. I’ve also covered the panel in […]
Read More
You can see this under the “New Panel” section as well, but here is our finished glare cover from FlightLine Interiors. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi […]
Read More