Here is something else we ran into. After having trouble building RPM and having a very rough running engine that seemed to want to run very lean, and ran relatively well at idle, but not at WOT. We tested the fuel flow from the injectors and found the below. Very uneven flow. After removing the […]
Read More
Here we’re doing miscellaneous filling and sanding to get the contours correct. Strake Door Finish Canard Mounting For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex ea […]
Read More
The door cover panels are pre-molded by the factory. There’s a hump where the door handle comes through, but figuring out where exactly was a bit challenging, so I ended up needing to close up my first hole a bit. Also, stealing an idea from my buddy Andy, I used left-over foam with a light BID […]
Read More
We’ve decided to create an augmented exhaust system for our plane (see Buffalo Forge paper on augmenters, also under “Downloads”). I foresee a couple of benefits from this. First, we don’t have the ‘rooster-tail’ that the factory exhaust creates by dumping out directly down from the cowling near the firewall. This creates a major disturbance to […]
Read More
You’ve got to have a data plate installed to be legal to fly. Our first data plate came form Aircraft Spruce, though later we’d look to get a specialized plate. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim […]
Read More
Check out our wings section for information on trailing edge wing fences for improved low speed handling. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex ea […]
Read More