Fresh Air Duct fitted, top strake skin internal seal layups done. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex ea commodi consequatur. Quis aute iure reprehenderit […]
Read More
You need to be logged in to view this content. Please Log In. Not a Member? Join Us
Read More
After we flipped the plane for Fuel Strake completion in Chapter 9, we went ahead and fitted the overhead fresh air duct since it was convenient. Special Report – ROLLOVER. Next we fit the lights (from a late model Jetta) and eyeball vents. The beauty ring on the vents were too big so we trimmed them, […]
Read More
Since the premolded engine cooling NACA ducts don’t seem to be covered elsewhere in the manual, I’ll include them here. Much of the cutting was completed during Head Start, though I did cut the overheard fresh air duct at home. Then they’re all fitted up and held in place. The engine naca’s had been set […]
Read More
Two runs of 1/2″ 3003 Aluminum tubing are run from the firewall up to the nose of the aircraft, and then covered in heat shrink tubing to add some insulation value to the line. At the aft end, the lines are installed with nuts and unions to a pre-made (by the factory) plate, and safety-wired. […]
Read MoreThe bird is flipped! Seats ready for upholstery (DVD screens installed!), auxiliary heating system, overhead switch panel, and antenna wiring complete. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex […]
Read More