We have to make a mating flange for the fuel servo, where the fuel is mixed with induction air. Here I’ve taken a piece of scrap aluminum with a paint cap glue to it, and then waxed and covered with a mess of BID. Once cured, just pop it all apart and trim. Fuel Servo […]
Read More
The engine plenum that we showed you above was a little too big, it was for the 300HP IO-540-K “angle-valve” motor. We have the IO-540-D, which is normally a 260HP motor, although ours is pumped up with high compression pistons and electronic ignition to above 300HP. Here are pictures of us glassing the fore and […]
Read More
This is the new compass location on the overhead switch panel, which alleviated the issue were were getting with interference and the compass not reading properly. Overhead mount Much better For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad […]
Read More
Yet another change. The magnetometer is moving again, it started on top of the landing light, but the light had a steel back-shell. Then it went onto the top of the canard, but the offset torque tube and the EFIS display case are steel, so it had to move. I decided to put it in […]
Read More
We’ve also been installing a backup battery for the EFIS to keep it up and running while the starting is drawing the primary battery down. This would also supply the EFIS for some time should the dual alternators and primary battery fail. The battery had to have a tray fitted to restrain it, and then […]
Read MoreInstrument Panel work, EFIS and other components installed. For formatting only Lorem ipsum dolor sit amet, consectetur adipisci elit, sed eiusmod tempor incidunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrum exercitationem ullam corporis suscipit laboriosam, nisi ut aliquid ex ea commodi consequatur. Quis aute iure reprehenderit in voluptate […]
Read More